Why This Vibration Monitor Board Protects Turbine Mechanical Components
The GE IS200VVIBH1C monitors vibration levels on Mark V turbine shafts. This board detects imbalance, misalignment, and bearing wear early. It connects directly to the VME backplane for high-speed data transfer. For this reason, the GE IS200VVIBH1C prevents catastrophic turbine failures from excessive vibration. It also triggers alarms before mechanical damage occurs.
Technical Specifications of the Board
We engineer this GE IS200VVIBH1C for precise vibration measurement. It operates on a 24V DC power supply from the VME rack. The board features four independent accelerometer input channels. Each channel includes a programmable gain amplifier for signal conditioning. On‑board capacitors provide energy storage for peak detection circuits.
| Specification | Value | Additional Notes |
|---|---|---|
| Full Model | GE IS200VVIBH1C | VME Vibration Monitor Board |
| Power Supply | 24V DC ±10% | From VME backplane |
| Vibration Inputs | Four differential channels | For accelerometer sensors |
| Input Range | ±10V or ±20V selectable | Software configurable |
| Frequency Range | 10Hz to 10kHz | Covers turbine vibration spectrum |
| Measurement Accuracy | ±2% of full scale | For amplitude readings |
| Alarm Outputs | Two relay contacts | Programmable threshold levels |
| Peak Detection | Analog peak hold circuit | Stores maximum vibration value |
| Energy Storage | Capacitor bank | 100µF for peak detection |
| Dimensions | 6U x 160mm x 233mm | Standard VME form factor |
| Weight | 0.72 kg (approximately) | Standard VME module weight |
| Interface Type | VME backplane + front panel | 96-pin DIN connector |
| Component Count | 96 discrete components | ICs, capacitors, resistors, relays |
Hardware Architecture and Signal Processing
The GE IS200VVIBH1C includes a dedicated DSP for real-time analysis. This processor calculates overall vibration amplitude for each channel. Moving to output side, two relays activate when vibration exceeds setpoints. The board also provides raw vibration data across the VME bus. Moreover, the H1C revision adds enhanced filtering for noisy environments. This improvement eliminates false alarms from electrical interference.
Installation and Calibration Guidelines
You must de‑energize the VME rack before removing this board. Remove the GE IS200VVIBH1C from its VME slot carefully. Then insert the replacement board into the exact same slot position. Verify all backplane pins align correctly with the connector. Skipping this step may cause incorrect vibration readings. Additionally, recalibrate each channel using a reference vibration source after installation.
Details
| Weight | 0.1 kg |
|---|---|
| Dimensions | 25 × 108 × 127 mm |
Reviews
There are no reviews yet.