Why This Servo I O Board Interfaces with Hydraulic Actuators
The GE IS200TSVCH1A IS200TSVCH1ADC connects servo valves to Mark V control systems. This board provides both command outputs and position feedback inputs. It supports precise control of fuel and steam admission valves. For this reason, the GE IS200TSVCH1A IS200TSVCH1ADC enables smooth turbine speed and load regulation. It also monitors valve position for diagnostic purposes.
Technical Specifications of the Board
We engineer this GE IS200TSVCH1A IS200TSVCH1ADC for accurate servo control. It operates on a 24V DC power supply with ±10% tolerance. The board features four analog command outputs for servo valves. It also includes four differential inputs for LVDT position feedback. On‑board capacitors provide energy storage for signal conditioning.
| Specification | Value | Additional Notes |
|---|---|---|
| Full Model | GE IS200TSVCH1A IS200TSVCH1ADC | Servo Input Output Terminal Board |
| Power Supply | 24V DC ±10% | For active circuitry |
| Command Outputs | Four analog outputs | ±10V or 4‑20mA selectable |
| Feedback Inputs | Four differential channels | For LVDT position sensors |
| Output Current | 20mA maximum per channel | For driving servo valves |
| Input Range | ±10V for LVDT feedback | Accepts position transducers |
| Resolution | 14‑bit on outputs and inputs | For precise control |
| Filtering | Low‑pass filter per channel | Removes valve dither noise |
| Energy Storage | Capacitor bank | 330µF for stable references |
| Dimensions | 220mm x 120mm x 60mm | Fits Mark V termination racks |
| Weight | 0.72 kg (approximately) | Includes all I/O circuitry |
| Interface Type | Backplane connector + screw terminals | Shielded for noise rejection |
| Component Count | 104 discrete components | Op-amps, ADCs, DACs, capacitors |
Hardware Architecture and Servo Control
The GE IS200TSVCH1A IS200TSVCH1ADC includes dedicated DACs for each command output. These converters generate smooth analog signals for servo valves. Moving to input side, four LVDT conditioners convert position to digital values. The board then transmits feedback data across the backplane. Moreover, the H1ADC revision adds enhanced output short-circuit protection. This improvement prevents driver damage from accidental wiring errors.
Installation and Calibration Guidelines
You must de‑energize the entire cabinet before removing this board. Disconnect all servo valve wiring from the GE IS200TSVCH1A IS200TSVCH1ADC first. Label each wire according to its terminal position. Then remove the board from its rack slot carefully. Insert the replacement board into the exact same slot position. Reconnect each wire to its corresponding terminal. Skipping this step may cause unstable valve operation. Additionally, recalibrate each servo channel after installation.
Details
| Weight | 0.1 kg |
|---|---|
| Dimensions | 25 × 108 × 127 mm |
Reviews
There are no reviews yet.