The GE IS200TDBSH2A IS200TDBSH2ACC terminal board connects field wiring to Mark VI control systems. This board provides a reliable interface between field devices and I/O modules. You will find this terminal board in Speedtronic Mark VI control cabinets and panels. Its high-density design accommodates forty field wiring points.
Termination Architecture
This terminal board provides forty screw terminal connections for field wiring. Consequently, you can connect many sensors without additional terminal blocks. The GE IS200TDBSH2A IS200TDBSH2ACC supports both analog and digital field devices. Moreover, each terminal includes a clearly marked identification number. You can terminate wires quickly using standard slotted screwdrivers.
Technical Specifications
| Parameter | Value |
|---|---|
| Terminal Count | 40 (screw clamp type) |
| Wire Gauge Range | 22 AWG to 14 AWG (0.34 to 2.0 mm²) |
| Voltage Rating | 250V AC / 150V DC maximum |
| Current Rating | 3A per terminal continuous |
| Contact Material | Brass with tin plating |
| Torque Specification | 0.5 Nm (4.4 lb-in) |
| Dimensions | 280mm x 170mm x 30mm |
| Weight | 0.62 kg (1.37 lbs) |
| PCB Layers | 4 |
| Onboard Components | 40 terminals, 2 jumpers, 1 ground bar |
| Connector Count | 2 (ribbon cable to I/O, ground stud) |
| Status Indicators | None (passive termination) |
| Energy Storage | None (passive board) |
| Isolation Voltage | 1500V (terminal to backplane) |
| Operating Temperature | -20°C to +60°C |
| Storage Temperature | -40°C to +85°C |
Field Wiring and Terminal Design
The unit uses high-quality screw clamp terminals for reliable connections. Therefore, wires stay secure even under vibration from turbine operation. This board replaces the IS200TDBSH2ACC version without any wiring changes. Simply remove the old board and install this one. GE designed this terminal board for single-slot installation. Hence, it fits directly into existing Mark VI rack positions.
Four PCB layers separate field wiring traces from backplane signals. Two connectors handle all signal and ground connections. The GE IS200TDBSH2A IS200TDBSH2ACC includes a dedicated ground bar for cable shields. Accordingly, you can terminate shield wires without additional hardware. This feature improves noise immunity in electrically noisy turbine environments.
Installation and Wiring Guide
You can terminate both stranded and solid copper wires easily. The screw clamps accept wires without special ferrules or lugs. The GE IS200TDBSH2A IS200TDBSH2ACC works with all GE Mark VI I/O modules. Always strip 6-8 mm of insulation before inserting wires. Proper torque on terminal screws prevents loose connections over time.
Each terminal position corresponds directly to a specific I/O channel. The board includes two configuration jumpers for signal type selection. The GE IS200TDBSH2A IS200TDBSH2ACC simplifies field wiring for turbine systems. Installation requires only a flathead screwdriver for terminal connections. This board operates reliably in non-condensing environments with adequate clearance.
Details
| Weight | 0.1 kg |
|---|---|
| Dimensions | 25 × 108 × 127 mm |
Reviews
There are no reviews yet.