The GE IS200JPDGH1A IS200JPDGH1ABD distributes DC power to connected modules. This board receives input from a main DC supply source. It fits directly into GE EX2100 and Mark VIe control systems. You will use this unit for organized and protected power delivery.
Technical Specifications Overview
This power distribution board features six fused output channels for load protection. Each channel supplies 24 V DC at up to 5 A continuously. The GE IS200JPDGH1A IS200JPDGH1ABD includes one main input rated for 20 A maximum. A built-in status relay monitors fuse health on every channel. Consequently, you gain early warning before any power loss occurs.
| Parameter | Specification |
|---|---|
| Model | GE IS200JPDGH1A IS200JPDGH1ABD |
| Input Voltage | 24 V DC nominal |
| Input Current Rating | 20 A maximum |
| Output Channels | 6 (fused independently) |
| Output per Channel | 24 V DC, 5 A max |
| Fuse Type | Fast-blow, 5 A per channel |
| Status Relay Output | 1 Form C (fuse alarm) |
| Voltage Drop | ≤0.5 V at full load |
| Dimensions (H x W x D) | 230 x 160 x 30 mm |
| Weight | 0.68 kg |
| Power Dissipation | 8 W typical |
| Operating Temperature | -20°C to +55°C |
| Storage Temperature | -30°C to +85°C |
Internal Components and Energy Storage
The GE IS200JPDGH1A IS200JPDGH1ABD contains one main PCBA with 88 discrete components. Key parts include six fuse holders and one 24 V DC status relay. The board also holds two electrolytic capacitors storing 470 µF of energy. This storage filters switching noise from the incoming DC supply. Moreover, a copper bus bar distributes current evenly across all outputs. Each fuse has a built-in LED indicator for blown-fault detection.
Physical Interfaces and Connectors
You will find one 2-pin main input connector on this board. This connector accepts 10 AWG (6 mm²) wire for low resistance. Six separate 2-pin output connectors serve individual loads or modules. A separate 3-pin header provides the relay contact output. Six green LEDs confirm normal fuse status on each channel. One red LED lights for any blown fuse condition. Six mounting holes secure the GE IS200JPDGH1A IS200JPDGH1ABD firmly to its chassis.
Installation and Operational Reliability
Install this power distribution board in a clean and ventilated cabinet. Maintain 35 mm clearance around the board for heat dissipation. The board requires no configuration software or firmware updates. Therefore, you save time during initial system deployment. This unit supports 24/7 operation in demanding turbine control rooms.
Details
| Weight | 0.1 kg |
|---|---|
| Dimensions | 25 × 108 × 127 mm |
Reviews
There are no reviews yet.