I/O modules

The GE IS200EPDMG1B IS200EPDMG1BAA Distribution Module supplies regulated DC power to multiple turbine control boards. This module accepts a single 24 VDC input source. It then distributes clean power across five independent output channels. You will find it mounting inside Mark VI system cabinets.

Core Technical Specifications

The GE IS200EPDMG1B IS200EPDMG1BAA Distribution Module measures 30.0 cm in width and 22.0 cm in height. Its board depth equals 4.5 cm including terminal blocks. The total assembly weighs approximately 1.2 kilograms. Five individual output channels occupy the module’s front section. Each channel delivers up to 3 amperes of continuous current.

Connectors and Status Indicators

The GE IS200EPDMG1B IS200EPDMG1BAA Distribution Module uses screw-type terminal blocks for all power connections. One input terminal block accepts the main 24 VDC supply cable. Five output terminal blocks connect to individual load boards. Five green LEDs illuminate for each active output channel. A red LED signals an overload or short circuit condition. Moreover, a yellow LED confirms input power presence.

Energy Storage and Protection Features

This distribution module contains small filter capacitors only on the input stage. Therefore, it stores very little energy after power disconnection. Each output includes a resettable PTC fuse for overcurrent protection. These fuses self-reset once the fault condition clears. Furthermore, the GE IS200EPDMG1B IS200EPDMG1BAA Distribution Module integrates reverse polarity protection on the input. This feature prevents damage from accidental wiring errors. You can reset an overloaded channel by removing and reapplying power. Do not exceed 3 A on any single output for extended periods. Keep the total load under 10 A for reliable operation. Use 14 AWG wire minimum for the main input connection.

​

Details